|
REFLECTIVE TAPE STORE HEAVY DUTY PREFORMED THERMOPLASTIC PAVEMENT MARKING ROLLS - BY THE "CASE" ITEMS SHIPPED "FAST" UPS or FREIGHT WITHIN THE U.S. Our "CASES" of Heavy Duty Preformed Thermoplastic Pavement Marking ROLLS contain 30 foot long rolls. Available in 4", 6", 8", 12", 18" and 24" width rolls. The number of rolls per case varies with roll width. Specifics of each case are outlined below. Preformed thermoplastic striping is extremely durable, and can be applied by anyone using a broom and a simple heat torch. Designed to be used as long term striping on highways and interstates, parking lots, bike paths, etc... Great for crosswalks, car spaces, stop pads, hazard areas, etc.. Available in white, yellow and handicap blue. Click here to order rolls in less than case quantities.  |
|
HAVE A QUESTION OR NEED A SAMPLE? CLICK TO EMAIL STEVE COLE e-mail or call me at 850-934-3157 9am-9pm |
 CLICK HERE FOR AN INSTALLATION VIDEO The number of rolls per case varies with roll width. Specifics such as number of rolls and total linear feet of striping per case are outlined below. Available in 4", 6", 8", 12", 18" and 24" width rolls. Our cases of preformed thermoplastic pavement marking tape ROLLS are designed to stripe asphalt parking lots, roads, bike paths and any other area where heavy duty, high visibility delineation is needed. It is great for creating crosswalks, car spaces, stop pads, hazard areas, etc.. This product will last 5 times longer than paint, is reflective and best of all, you can put it down yourself. No contractor required. Our tape is simple to install using a broom and a propane torch for asphalt or a broom, torch and thermobond for cement. No contractor required. It is 90 mils thick and has a durable, reflective surface. Since this is a melt on type product the tape will conform and bond to moderately rough surfaces or smooth surfaces and is incredibly tough. When properly installed you will get years of service out of this material. It can handle any type of traffic. To apply simply broom or blow off the dry, oil free area to be striped, heat the area with a propane torch, lay out the stripe and then slowly heat the surface of the stripe until a permanent bond is created. Once the material has cooled the area is ready for traffic. Please refer to the link above for complete instructions. It is important for this product to be installed properly. Note-for cement or concrete surfaces such as warehouse floors you will need to use "thermobond" which can be ordered at the bottom of this page. It creates an excellent bond with cement or concrete and substantially reduces the amount of heat necessary to install the thermoplastic striping. Thermobond can also be used on on asphalt to reduce application time. To use thermobond you mix an amount that you can use within 15 minutes and apply to either the back of the stripe, the pavement surface, or to both if you wish. Then lay the stripe down and heat the top of the stripe with a torch until the material conforms to the surface. (note that it does not take a tremendous amount of heat to get the material to conform) The thermobond will set in about 15 minutes and at that point the stripes are ready for traffic. This page is for ordering the rolls by the case. We have 4" cases in WHITE, YELLOW and HANDICAP BLUE. Other widths are available in white and yellow. Click here to order rolls in less than case quantities. Click here to order HANDICAP logos. Click here to order 12" WHITE material for Stop Bars and Crosswalks.
4" ROLLS ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($259.99 per case plus shipping)
click below: ($259.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below: ($299.99 per case plus shipping)
click below:  For bonding thermoplastic to cement surfaces use "thermobond". It is a heat activated adhesive specially designed for thermoplastic striping. Simply mix the amount you need, roll onto the ground or back of the stripe, lay on the ground and heat just enough to get the material to conform to the surface. The heat will activate the adhesive and create an excellent bond. Detailed instructions will be included with the thermobond. One gallon will adhere approximately 720 linear feet of 4" striping. Note - Thermobond may also be used on asphalt for superior bonding but is not necessary.) ($100.00 per gallon which includes shipping. Shipped from the manufacturer. May arrive separate from thermoplastic striping.)
click below:
If you wish to order with a check or money order you can send payment along
with a description of what you are ordering to 
About our products - We carry the finest quality industrial/commercial reflective tapes, reflective iron on tape, non skid tapes and pavement marking tapes available. Our parking lot striping tapes are manufactured using the highest quality raw materials that result in a durable application that is resistant to heavy traffic, water and grease.
|